HASSTA

Specifications

Electrical parameters

Light source	LED
Power voltage	AC 220–240 V / 50–60 Hz
Connection method	leading out cable, leading out cable with connector (G)
Ballast part	electronic driver with surge protection L/N-Ground 10 kV
Surge protection	EP + ballast with overvoltage protection 10 kV (S)
Possibility of regulation	non-dimmable (not labeled), DALI (DALI), night dimming (A) preparation for wireless communication NEMA (N), Zhaga (Z)
Constant luminous flux	CLO (C)

Light parameters

Optical system	roads (Mxx), roads (Lxx), directional (Pxx), area (Uxx) pedastrian crossing (ZLx/ZPx), combined optics (Kxx) BACK Light clonky (BL1), FRONT Light clonky (FL1)
Light distribution	direct, single-sided radiation (1), double-sided radiation (2)
Colour rendering index	Ra > 70, Ra > 80
Colour temperature	BLUE FREE (AMBER) / 2,200 K / 2,700 K / 3,000 K / 4,000 K / 5,000 K / 5 700 / TW
Service life	> 100,000 hrs. (L90B10)

Construction

Luminaire body	aluminum cast
Colour	RAL 7015
Surface type	matte
Luminaire cover	tempered glass

Safety

Protection class	I, II
Maximum ambient temperature	-35 / +45 °C
Ingress protection	IP 66
Impact protection	IK 08
Certification	ENEC
RoHS	YES
REACH	YES

Mounting

Method	pole mounted (48–67 mm)
Recommended height	max. up to 6 m
Use	city parks, cycle paths, lighting of outdoor railway areas, road classes II. and III., square, sidewalks

Variants

Luminaire ambient temperature TQ 25 °C
Initial color consistency: ≤ 5 SDCM
Optical and electrical parameters tolerance ± 10 %
The IDA Dark Sky seal of approval only applies to variants with CCT ≤ 3,000 K
To meet IDA Dark Sky requirements, ﬁxtures must be installed level with the roadway

When using the CLO function, the initial power and luminous fluxis 10 % lower than the value shown in the table.
LDT curves with CLO function have the letter “C” at the end of their marking.

The term BLUE FREE (AMBER) in lighting technology refers to light with a minimum amount of the blue part of the light spectrum ( <2 %).